Revalidation Guide

What to expect on your revalidation flight

To revalidate an SEP class rating by experience, you’ll fly at least one hour of refresher training with an instructor. There’s no pass or fail — it’s a chance to brush up your skills, and I’ll tailor the exercises to you.

The flight is based on the content of the CAA proficiency check (Form SRG1157). The four areas below are what we’re likely to cover, so you can prepare and arrive confident.

1

Departure

From planning on the ground through to the climb-out — showing you can prepare the aircraft and get airborne safely.

  • 1.1

    Pre-flight

    Documentation, mass and balance, weather briefing and NOTAMs.

  • 1.2

    Pre-start checks

    External and internal checks.

  • 1.3

    Engine starting

    Normal start, and how you would handle malfunctions.

  • 1.4

    Taxiing

  • 1.5

    Pre-departure checks

    Engine run-up (if applicable).

  • 1.6

    Take-off

    Normal take-off with Flight Manual flap settings; crosswind take-off if conditions allow.

  • 1.7

    Climbing

    Vx / Vy, turns onto headings and levelling off.

  • 1.8

    ATC liaison

    Compliance and R/T procedure.

2

Airwork (VMC)

General handling in visual conditions — accurate flying at different speeds and confident stall recognition and recovery.

  • 2.1

    Straight and level at various airspeeds

    Including flight at critically low airspeed, with and without flap.

  • 2.2

    Steep turns

    360° left and right at 45° angle of bank.

  • 2.3

    Stalling

    (i) Clean stall; (ii) approach to stall in a descending turn with bank, in approach configuration and power; (iii) approach to stall in landing configuration and power; (iv) approach to stall in a climbing turn with take-off flap and climb power.

  • 2.4

    Autopilot and flight director handling

    If fitted and applicable.

  • 2.5

    ATC liaison

    Compliance and R/T procedure.

4

Arrival and landings

Joining, approaching and landing in a variety of configurations — plus a well-flown go-around.

  • 4.1

    Aerodrome arrival procedure

  • 4.2

    Normal landing

  • 4.3

    Flapless landing

  • 4.4

    Crosswind landing

    If suitable conditions.

  • 4.5

    Glide approach and landing

    Approach and landing with idle power from up to 2,000 ft above the runway.

  • 4.6

    Go-around from minimum height

  • 4.7

    Night go-around and landing

    If applicable.

  • 4.8

    ATC liaison

    Compliance and R/T procedure.

5

Abnormal and emergency procedures

Rehearsing the situations you hope never to meet, so the right actions are second nature.

These exercises may be combined with sections 1 to 4 during the flight.

  • 5.1

    Rejected take-off

    At a reasonable speed.

  • 5.2

    Simulated engine failure after take-off

  • 5.3

    Simulated forced landing without power

  • 5.4

    Simulated emergencies

    (i) Fire or smoke in flight; (ii) systems malfunctions as appropriate.

  • 5.6

    ATC liaison

    Compliance and R/T procedure.

Know your aircraft’s numbers

Before the flight, please review your aircraft’s Pilot’s Operating Handbook (POH) and be familiar with the relevant airspeeds — take-off and rotation speeds, climb speeds (Vx and Vy), stall speeds, best glide, and the approach speeds for each landing profile (normal, flapless, short-field and glide approach). Knowing these makes the stalling, emergency and landing exercises far more rewarding.

Example Airspeeds

Typical speeds for common training aircraft

All speeds in knots indicated airspeed (KIAS), typically at maximum weight.

These figures are examples for guidance only. Speeds vary by model year, serial number, engine and weight. Always use the POH/AFM for the specific aircraft you are flying.

Cessna 172

172S Skyhawk

Rotation (Vr)55
Best angle climb (Vx)62
Best rate climb (Vy)74
Stall — clean (Vs1)48
Stall — landing config (Vso)40
Best glide68
Normal approach (full flap)60–70
Short-field approach61
Max flap extended (Vfe)110 (10°) / 85 (>10°)
Manoeuvring (Va)105
Max structural cruise (Vno)129
Never exceed (Vne)163

Cirrus SR20

G6

Rotation (Vr)65–71
Best angle climb (Vx)81
Best rate climb (Vy)96
Stall — clean (Vs1)65–71
Stall — landing config (Vso)62
Best glide92–100 (weight dependent)
Final approach (Vref, 100% flap)78
Max flap extended (Vfe)150 (50%) / 110 (100%)
Manoeuvring (Va)133
Max structural cruise (Vno)164
Never exceed (Vne)201
Max demonstrated CAPS deployment133

Cirrus SR22T

G5 / G6

Rotation (Vr)~70
Best angle climb (Vx)88
Best rate climb (Vy)103
Stall — clean (Vs1)74
Stall — landing config (Vso)60
Best glide88
Final approach (100% flap)77–80
Max flap extended (Vfe)150 (50%) — check POH for 100%
Operating manoeuvring (Vo)140
Max structural cruise (Vno)176 (to 17,500 ft)
Never exceed (Vne)205 (to 17,500 ft)

Vno and Vne reduce with altitude above 17,500 ft.

Piper PA-28-161

Warrior II / III

Rotation (Vr)50–55
Best angle climb (Vx)63
Best rate climb (Vy)79
Stall — clean (Vs1)50
Stall — landing config (Vso)44
Best glide73
Normal approach (full flap)63–66
Max flap extended (Vfe)103
Manoeuvring (Va)111 (at 2,440 lb)
Max structural cruise (Vno)126
Never exceed (Vne)160

Diamond DA40

DA40 180 (Avgas)

Rotation (Vr)59
Best angle climb (Vx)Not published
Best rate climb (Vy)66–73 (weight dependent)
Stall — clean (Vs1)52
Stall — landing config (Vso)49
Best glide73
Normal approach (landing flap)~70
Max flap extended (Vfe)108 (T/O) / 91 (LDG)
Manoeuvring (Va)108
Max structural cruise (Vno)129
Never exceed (Vne)178

Diamond does not publish a Vx for the DA40; Vy is normally used.